Pleasure Center

Specific200 · #1 3rd February 2007, 04:32 AM

Passed though here the other night on the raod. There are a few covered holes in the back two booths. One of them is in the process of being opend back up. The thing is, the covered holes are so clsoe to each other that if one wanted to undo the covers--simple locking nuts with a stud going through to the other side--it would be easy to use a small, thin hand saw easily carried in a pocket to connect them. The holes are way to small to get it through, about 1", but if they were conencted, it wood be plenty big enough.

I don't know who keeps drilling holes, but they are using a hole saw way too small, and the wall is starting to look like swish chessh.

There are also three coverd holes, all about 1", in the first two booths. The holes are about 3/4 of an inch from each other, so the same thing applies. If the covers sould be gotten off, it would be really easy to connect tehm and make a hole about 3 " in diameter.

There is another option, and it may go unnoticed forever. USing teh same samll hand saw, one could use it to cut eh partition up away from teh floor about 6" more, and it would be enough to slide under. If it was done correctly, it may not look suspicoious at all. The partition is about 3" off the floor now. Anotehr 5 " would probably make it feasible without looking wrong.

The problem is getting the wood out of the place. That makes it a no go probably. If one had a large jacket on, you could probalby break or saw the particle baord in half and carry two pieces about 24" each under your coat easily enough.

The only other thing I can think of is cutting a hole large enough in the first place, and then putting a psuedo cover back over it that is secureable someway. Hopefully people would replace it after they were done, and the owners would never know. But that is probably not going to work.

Once again, this is NOT a cruiser gallery. Don't push it. They do monitor the back. People do jack off in the booths, but it's usually very empty and they keep to themselves.

goodtymes55555 · #2 4th February 2007, 09:24 PM

where is pleasure center???

Specific200 · #3 17th February 2007, 10:40 PM

Ther is a hole opened now just large enought o get my dick all the way in, but very tight and rough cut. I would suggest going to the far booth if you want to slide it thorugh. The other booth has all the bolts sticking thorugh like a pin cushion.

Be descreet.